HXGN□-12箱型固定式金屬封閉開關設備概述 Overview

HXGN □ -12（SF6）型單元式交流金屬封閉環網開關設備（以下簡稱環網柜）是我們在引進技術并按照國內農電及城網改造之要求而自行設計、研制成功的新一代高壓電器產品。各項技術性能指標全部達到IEC298和GB3906標準。

環網柜的主開關、操作機構及元器件采用ABB 公司原裝件或采用進口部件國內組裝生產的SFL-12/24型開關設備，也可根據用戶需要配裝ABB公司原裝HAD/US型SF。斷路器或VD4-S型真空斷路器，其操作方式分為手動、電動兩種。

柜體經數控機床加工后鉚接而成，防護等級達到IP3X，并有可靠的機械聯鎖和防誤操作功能。本產品具有體積小、重量輕、外形美觀、操作簡便、長壽命、高參數、無污染、少維護等顯著的特點。

HXGN □ -12(SF6) Unit type AC metal-enclosed ring main unit(hereafter refer to as ring net cabinet) is a new generation of high-pressure electric appliance product designed and developed independently by our own company according to the requirement of the domestic agricultural electricity and the city net transformation after introduction of overseas advanced technology. Each technical performance index completely reaches the IEC298 and GB3906 standard.

The loop-net cabinet s main switch, the operating mechanism and the components is made of the ABB Corporation original piece or the SFL-12/24 switch equipment imported overseas and assembled at home. We can also install the ABB Corporation original piece of HAD/US type SF according to the request of users. The circuit breaker or the VD4-Svacuum circuit-breaker divide into two kinds: be operated manually and electrically according to the operating mode.

The cabinet body is riveted after processed by numerical control machine tool with reliable mechanical interlocking and the misoperating prevention function. The protection grade reaches IP3X.This product has the remarkable characteristics such as the small volume, light weight, artistic appearance, simple operation, long life, high parameter with no pollution and little maintenance.

HXGN□-12箱型固定式金屬封閉開關設備使用環境條件 Use of Environmental Conditions

1、海拔不超過2000m

2、周圍空氣溫度：上限+40℃下限-25℃

3、相對溫度：日平均值不大于95%，月平均值不大于90%

4、周圍空氣不受腐蝕性氣體或可燃性氣體、水蒸氣等明顯污染

5、無經常性的劇烈振動

1. The altitude should not exceed 2000m.

2. Surrounding air temperature: -25℃ ~+40℃

3. Relative temperature: the daily average value is not higher than 95%, the the monthly average value is not higher than 90%

4. Surrounding air without caustic gas or ignitable gas, steam and other obvious pollution

5. Without fierce vibration

HXGN□-12箱型固定式金屬封閉開關設備用途  Purpose

HXGN □ -12（SF6）型單元式交流金屬環網開關設備，適用于交流50Hz??12K 中，作為電能的接受和分配之用。

HXGN □ -12 (SF6) unit type exchange metal ring- net switching equipment, is suitable to exchange 50Hz、12K, searving as device of receiving and distribution of electrical energy.

HXGN□-12箱型固定式金屬封閉開關設備產品型號及其含義  Model and meaning

HXGN□-12箱型固定式金屬封閉開關設備主要技術參數 The main technical parameters

HXGN□-12箱型固定式金屬封閉開關設備結構特點及工作原理  Structural Characteristics and Working Principle

產品外形結構見圖1、圖2，安裝尺寸如圖3所示。本環網柜是以空氣為絕緣介質的，主要配裝ZFN□-10/630型真空負荷開關，主要方案有進線柜和出線柜等。

1. 進線柜方案

柜內主回路有一臺ZFN□ -10/630 型真空負荷開關，它配裝有隔離刀、酌情還配裝接地刀所組成，三者共裝在一個機架上，并互有聯鎖。因此可實現接通母線、隔離、接地三個工位的操作，柜內還可靈活配裝CT、PT等元件。

2. 出線柜方案

柜內主回路有一臺ZFN□-10/630型真空負荷開關和帶撞擊器的熔斷器(有隔離開關的作用)及接地刀所組成，也可實現三工位操作，柜內還可靈活配裝 CT/PT 和ZNO避雷器等元件，因此有時可省去計量柜。進、出線柜均配有與接地開關聯鎖的絕緣防護隔板，柜內各開關與隔板及柜門間采用機械聯鎖，并達到“五防”要求，柜體外殼防護等級為IP2X。

The outline structure of the product is referred to as diagram 1 and diagram 2; the installation dimension is referred to as diagram3. This ring network type cabinet makes air as the insulating medium,mainly assembled with ZFN □ -10/630 type vacuum load switch. And there are two cabinet schemes - incoming cabinet and outgoing cabinet.

1. Incoming cabinet scheme

There is a ZFN □ -10/630 type vacuum load switch on the main circuit inside the cabinet with isolating knife, and grounding knife conditionally. The three of them are all installed in one machine stａnd and there are interlocks among them, so that it is realized to connect the operation of three working stations of bus, isolation and grounding. Inside the cabinet the components such as CT, PY are available.

2.Outgoing cabinet scheme

ZFN □ -10/630 type vacuum load switch, fuse with striker (used as isolating switch) and grounding knife on the main circuit inside the cabinet, and the three working stations operation can be realized. Inside the cabinet the components such as CT/PT and ZNO arrester are available, so the metering cabinet can be omitted. Inside the incoming cabinet and outgoing cabinet, there is insulating protecting baffle interlocked with grounding switch. And inside the cabinets ,the mechanical interlocks are adopted between each switch and baffle as well as the cabinet door with the requirement of “five-prevention” and IP2X of the protection degree of the cabinet enclosure.

HXGN□-12箱型固定式金屬封閉開關設備安裝基礎圖 Installation base map